How to Install Bathroom Towel Bars

Bathroom towel bars are a very important part of the bathroom. These are the bars that you use to display and hang the towels, and hand towels that may be used while in the bathroom. You will need to ensure that the towel bars are sturdy and strong enough to hold even a wet towel. This is why it is important to take special care and consideration when installing these units. Here, I will provide you with the steps needed to install bathroom towel bars.

Supplies Needed:

In order to properly install a towel rack, or towel bar, you will need a few essential supplies. They are as listed below:

1. The towel bars that you will install

2. A level to ensure that the towel bar is even

3. A stud finder

4. Various types of screw drivers

5. Anchor or anchors for the wall

6. Masking tape

7. Measuring tape

8. Electric drill

9. Bits for the drill

10. Pencil

Steps:

1. The first step to installing a bar for towels in the bathroom is to decide where you want the item to be placed. It is best to install this bathroom accessory near the bathtub or the shower unit in the bathroom. Many individuals often elect to place these units near the sink area in the bathroom. The only thing that you need to concern yourself over at this point is whether or not you have the room to accommodate the overall length of the towel bar in the areas that you are interested in placing them. If you do, then it can work. If not, you will need to find an area that will work as far as the overall length is concerned.

2. Now, when looking around for places that you can place a towel bar, it is important to ensure that you avoid placing it in areas that can cause damage. For example, it is important to ensure that you do not place them so that the bathroom door or the closet door can hit the bar. If this happens enough, damage will occur. Also, you do not want to place the towel bar too low – especially if pets and animals are in the home. It is best to place the towel bars up to about forty eight inches off the ground.

3. Once you have identified the area where you will install the towel rack, use the stud finder to ensure that the screws will be inserted into the wall studs. If the screws will not line up with the wall studs, you will need to adjust as appropriate.

4. Once you have identified the area where the screws will be inserted, you can simply place a small piece of masking tape here to mark the area.

5. Now, you will take the wall mounts and install them in the designated area.

6. Once the mount is installed, you will install the actual towel bar on the wall.

7. You will want to test out the durability of the towel bar to ensure that it is tight and secure. Once you confirm this, you are all done!

Conclusion

Installing bathroom towel bars is a relatively easy task. The most difficult aspect of the entire job is choosing a location, and making sure the bar is even. The rest is easy!